Submerged arc welding (SAW), as the name suggests, is conducted beneath a protective layer or blanket of flux. As the arc is always covered by the thickness of flux, it eradicates any radiation from the exposed arches and also the necessity of welding screens. With two variants of the process, automatic and semi-automatic, is one of the widely used welding process used in the process industry. Wenzhou Tianyu Electronic Co., Ltd., one of the renowned submerged arc welding wire suppliers in China, illustrates the principle and uses of sub-arc welding. Let us see them what they are:
Process:
Akin to MIG welding, SAW also employs the technique of formation of an arc between the weld joint and the continuous bare electrode wire. A thin layer of flux and slag are used to generate protective gas mixtures and to add the required alloys to the weld pool, respectively. As the weld proceeds, the electrode wire is released at the same rate of consumption and the excess flux is sucked out through a vacuum system for recycling. Apart from shielding the radiation, flux layers also are highly beneficial in avoiding heat loss. The excellent thermal efficiency of this process, around 60%, is attributed to these flux layers. Also SAW process is absolutely free of spattering and does not require any fume extraction process.
Operating procedure:
Alike any other welding procedure, the quality of the weld joints concerning penetration depth, shape and chemical composition of the weld metal deposited are usually controlled by the welding parameters such as current, arc voltage, weld wire feed rate, and weld travel speed. One of the drawbacks (of course methods are available to counter them) is that the welder cannot have a look on the weld pool and hence the quality of well is entirely dependent on the operating parameters.
Process parameters:
As mentioned earlier, it is only with the process parameters, and a welder perfects the weld joint. For instance, in an automated process, the wire size and flux that employed that are suitable for the common type, thickness of material, and size of the job plays a vital role in deciding the deposition rate and bead shapes.
Wire:
Depending upon the requirement of deposition rate and travel speeds following wires can be selected
·Twin-wire
·Multiple wires
·Tubular wire
·Metal powder addition
·Single wire with hot addition
·Single wire with cold addition
Flux:
The granular mixture of oxides of several elements such as manganese, titanium, calcium, magnesium, silicon, aluminium, and calcium fluoride is widely used as a flux in SAW. Usually, the combination is selected such that it provides the intended mechanical properties when it combines with the welding wire. It should also be noted that the composition of these fluxes plays a vital role in the operating arc voltage and current parameters. Based on the welding requirement, primarily two types of fluxes, bonded and fused are employed in the process.
Uses:
Every welding method has its own set of applications, which usually overlaps due to the scale of economy and quality requirement.
Although SAW can be very well employed for both butt joints (longitudinal and circumferential) and fillet joints, it has few minor restrictions. Owing to the fluidity of the weld pool, slag in the molten state and a loose layer of flux, butt joints are always carried out in the flat position, and on the other hand, fillet joints are done in all positions – flat, horizontal, and vertical.
It should be noted that as long as proper procedures and selection of parameters for joint preparations are carried out, SAW can be successfully carried out for material of any thickness.
It can very well be deployed for carbon steels, stainless steels and low alloy steels and also few non-ferrous alloys and materials, provided the ASME code suggested combinations of wire and flux are used.
SAW finds a permanent place in heavy machine industries and shipbuilding industries for substantial welding sections, large diameter pipes, and process vessels.
With very high utilisation of electrode wire and accessible automation possibilities, SAW is always one of the most sought after welding process in the manufacturing industry.
Post time: Dec-23-2022